Видео

The diamonds are for truss joists or sometimes called engineered joists, not typically for framing lumber floor joists,

Go dawgs!

You mispelled Vevor in the title

Nice😊😊

Have you checked for grub worms? Those bald spots look also like grub worm damage. Your video didn’t relate to your title with enough information about the sprayer.

You said that the most common board for four joints is 8 ft then you said 8 ft is 144 inches

2002 ford explorer

You also need to check the resistant between the electrode to ground of the spark plug,If it appear some resistant it will reduce the strengh of the Spark(ark).It still cause some light missfire.

Thank you you explain the problem very easily again thank you very hank you very much and

Thanks so much

Ehat about 80 series

You rushed and lazily slopped on the stain. For such a small job. Terrible. 3.5 effort stain skills

My washer will go through all the cycles except the spin and drain. It does agitate/mix the clothes but won’t drain or spin dry. Could my motor be shot?

fan is not moving at all with no sound? My ac turns on, but exterior fan does not turn on and i have zero aound. Air coming out of vents is not warm nor cool. In between.

That Hex Nut and bolt fell off my unit, any special instructions to reinstall it?

Hi, I have the device around 5 meters from gateway with a wall between them and I have a lot of problem with the connection. Gateway ok, device disconnected for a lot of time. Any solution?

I have an 80 Series but NO lid switch, help?

What if it has no sound or no way of checking?

We bought our house in 2020 and all three toilets over time went from pristine white with standard, regular cleaning to...red/brown/black stains. We have well water and after enough googling I realized it was build up of minerals over time. We know our water is high in manganese. I picked up your recommendation and let it sit over night. While I totally skipped the warm water part, it cleared up 90% of what was in the tank minus a little debris at the edges. Awesome video, extremely helpful, this did exactly what it needed to do. Thanks!

This video was fantastic! I was able to fix one switch by just switching it into the other side and ordered from your link the others I needed. Both bulbs were good. Now I have extras. 7.99 for bulbs ,tool and a we itches! Perfect. People’s comments helped too!

I got a hilux 2kD and it has the check light still on.we even got the harness,sensors and even engine was changed but still the check light won't go off😢

Excellent video! Thank you!

I appreciate you bro thank u

Definitely flip the breaker and I always clean the bottom of the oven at the same time .........just saying.

Thank you kind sir!!!! I just replaced two sets of blinds today and fell pretty good about myself lol on to the other home projects. Thanks again.

your hands blocked your multimeter screen, could't see the reading results. Also, Though I'm a little, little bit deaf, I didn't hear the beep but once, and you stated the switch was good, I'll take your wood, Is it possible that the switch could indicate continunity but have too much of resistance for elictrical current flow?

Do you have a video for driver side blend door actuator replacement. I heard some fluttering down by console now the air goes in and out but it’s colder on the passenger side 2011 Honda pilot

Your hands were blocking the whole procedure - - >>

great explanation, great video ... there should be more of guys like you on youtube...

🙏🙏🙏🙏👏👏👏

Very very good!!!!!!!

Solution achieved. Replaced positions of the sensors it worked!!! Yes I did have to splice the wires as they were home-run wiring. Already had the wire nuts. Just a few minutes of your time.

Sorry. You made two major errors. One was being 1000 ohms off several times, which you corrected once in the voice over. The other was referring to the broken plug as having no resistance. No resistance would be indicated by 0. Your meter showed no conductivity, the opposite of no resistance.

Discovered my door is doing exactly this. The bright Sun. Works fine in the Morning or Evening. Less than 3 years old. Sensors look new like the ones you installed. May try the paper block piece.

What if your coil isn't broken but the heating element is cracked in spots? Could it cause the same issues?

As others say, your vid is clear and especially VISUALLY well shot to be helpful. I'lll embark on my repair soon with less anxiety. Not sure what brand my vintage plastic-crystal knobs are (their placement is separated by the faucet in-between). But I guess I can bring my old parts to the plumbing supply. Thanks from an aspiring DIYer!

Thank you This video was helpful.

Why does my 09 pilot have hb3 9005 headlights instead of h11? When I look it up, my make and model should have h11 bulbs. Does anyone know why?

My first thought was: "Wow, what a ridiculous dumb method to measure something. Dividing by 12 ? Are you kidding! Using fractions for exact measures? You must be joking!" But then I thought: "If they like it that complicated, not my problem"

PS it works.

Thank you. I have had a broken canopy sitting in the shed for 3 years, not wanting to throw it away because it cost me £200 (I live in the UK)and I only used it twice. Hopefully I can follow your method and fix it.

Thx!!!

I’m doing something wrong getting the lower drive belt front pulley loosened. I have an impact wrench on it and it won’t budge. I’m afraid it will break if I keep using the impact on it. Please tell me it’s not threaded in reverse.

Thanks dude. Solved my issue!

Ps. The fire extinguisher that I moved when cleaning let the door close but not all the way. Just a helpful hint for others

Thank you for your information. You fixed my freezer.😊

Precise and to the point. No BS talking about a bunch of crap you don’t need to do. Good to see a man with common sense. 👍

Confirms everything I think about a nation that breeds consumers for total shit

The solenoid locations are ridiculous and hard to deal with. Now I have to go recheck my ground. I have to disconnect and remove my battery just to get to it and have to reinstall everything just to TEST it. In 3 seasons, my solenoid has failed 3 times. Why couldn't it be something easy. Good video and good camera work. Thanks for the help.

It’s a how to video …….how not to do it…..